Table of Contents
Advertisement
FS-8700-84_Lutron_eLumen Driver Manual
4.1.34.
System Control Commands containing no Parameters: Simulate wallstation(s) switch release
// Client side Map Descriptors
Map_Descriptors
Map_Descriptor_Name,
Data_Array_Name,
Ws_sw_rls,
Lut_triggers,
DA_Lut_List data setup
Position from DA_Lut_List_Offset
0
1
2
3
4
..
63
64
Note: 1 to 32 switch ids may be used in a single command. To trigger the command, write the number of switch IDs into the Data Array specified
by Data_Array_Name at Data_Array_Offset.
4.1.35.
System Control Commands containing no Parameters: Stop scene ramp down
// Client side Map Descriptors
Map_Descriptors
Map_Descriptor_Name,
Data_Array_Name,
Stop_scn_rmp_dn,
Lut_triggers,
DA_Lut_List data setup
Position from DA_Lut_List_Offset
0-31
Note: After setting up the area numbers to stop scene ramps in the DA_Lut_List Data Array, trigger this command by writing the number of areas
into the Data Array specified by Data_Array_Name at an offset specified by Data_Array_Offset.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com
Data_Array_Offset,
Function,
Node_Name,
17,
awt,
LUT_GRF6_0,
Description
Link number ( 0-11 )
Station of link ( 0-31 ) of Switch ID 0
Switch on station ( 0-31 ) of Switch ID 0
Station of link ( 0-31 ) of Switch ID 1
Switch on station ( 0-31 ) of Switch ID 1
..
Station of link ( 0-31 ) of Switch ID 31
Switch on station ( 0-31 ) of Switch ID 31
Data_Array_Offset,
Function,
Node_Name,
18,
awt,
LUT_GRF6_0,
Description
Area(s) with scenes to stop ramp down
Page 26 of 36
GRAFIK_command,
DA_Lut_List,
sim_ws_sw_rls,
Sim_sw_list,
GRAFIK_command,
DA_Lut_List,
stop_scene_ramp_dn,
Area_list,
DA_Lut_List_Offset,
Length
0,
1
DA_Lut_List_Offset,
Length
0,
1
Advertisement
Table of Contents
