Table of Contents
Advertisement
FS-8700-88 Envirotronics SystemsPlus
3.
Hardware Connections
The FieldServer is connected to the SystemsPlus Controller as shown below.
Configure the SystemsPlus Controller according to manufacturer's instructions.
"
"
"
Note:
The SystemsPlus Controller MUST be set to COMMAND MODE using the manufacturer's
software before connecting the FieldServer.
The SystemsPlus Controller's "Command End of Line" setting MUST be set to "CR". Using
the manufacturer's software to do this setting before connecting the FieldServer
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com
# &
!
$
%!
& " !!
(
&
$
#
# &
!
" !!
#
!
!
' )
' "!
!
!
!
! , -
- . / . 0. 12 3.
2 2
Page 7 of 49
*
#+ (
Advertisement
Table of Contents
