Installation; Preparations - Husqvarna AUTOMOWER 305 Operator's Manual

3. Installation

This chapter describes how to install the Husqvarna
robotic lawnmower. Before starting the installation
read the previous chapter 2. Presentation.
Read also through this entire chapter before beginning
the installation. How the installation is done also
affects how well the robotic lawnmower works. It is
therefore important to plan the installation carefully.
Planning is simplified if you make a sketch of the
working area, including all obstacles. This makes it
easier to see the ideal positions for the charging
station, the boundary wire and the guide wire. Draw on
the sketch where the boundary and guide wires should
be routed.
In the 7. Garden examples chapter, there are
examples of installations.
Visit also www.automower.com for further descriptions
and tips regarding installation.
Carry out the installation in the following steps:

3.1 Preparations

3.2 Installation of the charging station
3.3 Charging the battery
3.4 Installation of the boundary wire.
3.5 Connecting the boundary wire.
3.6 Installation of the guide wire
3.7 Checking the installation.
3.8 First start-up and calibration
3.9 Test docking with the charging station
The charging station, boundary loop and guide wire
must be connected to be able to carry out a complete
start-up.
3.1 Preparations
1. If the lawn in the working area is longer than
10 cm, mow it using a standard lawnmower.
Then collect the grass.
2. Read carefully through all the steps before the
installation.
3. Check that all parts for the installation are
included. The numbers in brackets refer to the
component illustration 2.1 What is what?.
• Operator's Manual (24)
• Robotic lawnmower
• Charging station (6)
• Loop wire for boundary loop and guide wire (16)
16 - English
3. INSTALLATION
3012-930