Installation Of The Charging Station - Husqvarna AUTOMOWER 305 Operator's Manual

Hide thumbs Also See for AUTOMOWER 305:
Table of Contents

Advertisement

• Transformer (20)
• Low voltage cable (17)
• Staples (21)
• Connector for connecting the loop wire to the
charging station (18)
• Screws for the charging station (19)
• Measurement gauge (22)
• Couplers for the loop wire (23)
During installation you will also need:
• Hammer/plastic mallet (to simplify putting the
staples in the ground).
• Combination pliers for cutting the boundary
wire and pressing the contact strips together.
• Edge cutter/straight spade if the boundary wire
must be buried. Installation of the charging
station.
3.2 Installation of the charging
station
Ideal position for the charging station
Take the following aspects into consideration when
identifying the best location for the charging station:
• Allow for 3 metres of free space in front of the
charging station.
• It must be possible to lay at least 1.5 metres of
boundary wire straight out to the right and left
of the charging station.
• It must be close to a wall socket The supplied
low voltage cable is 10 metres long.
A 20 meter low voltage cable is available to
purchase as an accessory. Please contact
your dealer for more information.
• A level surface to place the charging station
on.
• Protection from water spray for instance from
irrigation.
• Protection from direct sunlight.
• Place in the lower part of a working area that
has a major slope.
For an example of an ideal position of the charging
station, see 7. Garden examples on page 53.
3. INSTALLATION
3018-057
3018-072
English - 17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Automower 308

Table of Contents