HP BACKCOPY Reference Manual page 236

8012
Duplicate volume ID found in the VOLUME attribute of the tape
DEFINE define.
Cause. A labeled tape volume ID was specified more than once in the VOLUME attribute's list of
volume IDs.
Effect. BACKUP or RESTORE terminates.
Recovery. Specify a unique list of labeled tape volume IDs.
8013
Tape volume IDs for the two parallel copies are not unique.
Cause. A labeled tape volume ID was specified in both VOLUME attribute lists of a parallel backup.
Effect. BACKUP terminates.
Recovery. Specify lists of labeled tape volume IDs for the two parallel copies that are unique for
the whole parallel backup operation.
8014
The attribute attribute was specified for the tape DEFINE
define and it is not allowed.
Cause. A DEFINE attribute was specified that is not allowed.
Effect. BACKUP or RESTORE terminates.
Recovery. Specify a DEFINE that has attributes from this list: DENSITY, EXPIRATION, LABELS,
MOUNTMSG, OWNER, RETENTION, SYSTEM, TAPEMODE, and VOLUME.
8015
VOLUME SCRATCH specified for input in the tape DEFINE define.
Cause. SCRATCH was specified instead of a list of volume IDs.
Effect. RESTORE terminates.
Recovery. Specify a DEFINE with the list of volume IDs to use.
8016
Value for the tape DEFINE attribute DENSITY conflicts with
the DENSITY parameter.
Cause. The density value specified with the BACKUP DENSITY parameter is different than the value
specified with the tape DEFINE attribute DENSITY.
Effect. BACKUP terminates.
Recovery. Either specify the same density value for the BACKUP DENSITY parameter and the tape
DEFINE attribute DENSITY, or omit one of these specifications.
236 BACKCOPY, BACKUP, and RESTORE Messages