HP BACKCOPY Reference Manual page 210

Guardian disk and tape utilities
Table of Contents

Advertisement

7504
Bad tape format (Bad length for a DP2 tape file label).
Cause. An attempt was made to restore a tape, but a BACKUP tape in the proper format could not
be found. There are three possible reasons:
BACKUP was stopped in the middle of a backup operation, resulting in an incomplete BACKUP
tape. The "Bad Tape Format" was detected when unwanted or meaningless information was
encountered at the interruption point on the tape.
The BACKUP tape was corrupted in some way.
Either BACKUP produced an invalid tape or RESTORE is not checking correctly due to a
software error.
Effect. RESTORE terminates.
Recovery. If the invalid format is the result of one of the first two causes, the files cannot be restored.
If you suspect the problem is a result of the third cause, contact your service provider and provide
all relevant information:
The information in this message
Description of the problem and accompanying symptoms
Supporting documentation such as Event Management Service (EMS) logs, trace files, and a
processor dump, if applicable
If your local operation procedures require contacting the GCSC, supply your system number and
the numbers and versions of all related products as well.
7505
Bad tape format (End-of-file encountered where file label or
ending volume label expected).
Cause. An attempt was made to restore a tape, but a BACKUP tape in the proper format could not
be found. There are three possible reasons:
BACKUP was stopped in the middle of a backup operation, resulting in an incomplete BACKUP
tape. The "Bad Tape Format" was detected when unwanted or meaningless information was
encountered at the interruption point on the tape.
The BACKUP tape was corrupted in some way.
Either BACKUP produced an invalid tape or RESTORE is not checking correctly due to a
software error.
Effect. RESTORE terminates.
Recovery. If the invalid format is the result of one of the first two causes, the files cannot be restored.
If you suspect the problem is a result of the third cause, contact your service provider and provide
all relevant information:
The information in this message
Description of the problem and accompanying symptoms
Supporting documentation such as Event Management Service (EMS) logs, trace files, and a
processor dump, if applicable
If your local operation procedures require contacting the GCSC, supply your system number and
the numbers and versions of all related products as well.
210
BACKCOPY, BACKUP, and RESTORE Messages

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

PakUnpakRestoreDcomDsapBackup ... Show all

Table of Contents