HP BACKCOPY Reference Manual page 280

Cause. The -password option was given in the UNPAK command, but the encryption version used
in the archive file is not supported. The only supported version is 1.
Effect. The program stops with completion code 2. No files are extracted.
Recovery. Use a correct file name, remove -password, or re-create the archive.
Warning: file might be corrupt
Cause. UNPAK tries to read the archive but notices one of these conditions:
The length of the text stored with the -c, -after, or -comment option is longer than 255
characters.
The size of the archive stored in the file header is not equal to the actual EOF of the file. The
PAK operation was interrupted when the archive was created or the file was otherwise
truncated.
Effect. The program continues but might fail later.
Recovery. None if the operation succeeds. Otherwise re-create the archive.
Warning: file might be corrupt (expected EOF=num)
Cause. UNPAK tries to read the archive, but the size of the archive stored in the file header is not
equal to the actual EOF of the file. The PAK operation was interrupted when the archive was
created or the file was otherwise truncated.
Effect. The program continues but might fail later.
Recovery. None if the operation succeeds. Otherwise re-create the archive.
WRITEX failed: error
Cause. The call to WRITEX failed while sending the startup message to the BACKUP or RESTORE
process. error is the file-system error retrieved with FILE_GETINFO_.
Effect. The program abends. Possibly a saveabend file is created. No archive is created, and no
files are extracted.
Recovery. This is an internal error. Report it to your service provider.
Wrong password
Cause. The archive file is encrypted, but the password in -password is wrong.
Effect. The program stops with completion code 2. No files are extracted.
Recovery. Supply the correct password and try again.
Output file exceeded its limit, cannot write in Output file
further
Cause. The OUT option is specified in PAK/UNPAK command and the output file reaches the
maximum file limit while writing log records.
Effect. The program stops with completion code 2. The created archive file is purged or unpacking
operation is stopped.
Recovery. Resubmit the command by splitting the file set into subsets such that all files in the subset
can be logged in one output file or run PAK/UNPAK command without OUT option.
280 PAK/UNPAK Messages