HP BACKCOPY Reference Manual page 218

Recovery. If the invalid sequence number is a result of one of the first two causes, the files cannot
be restored. If you suspect the problem is a result of the third cause, contact your service provider
and provide all relevant information:
The information in this message
Description of the problem and accompanying symptoms
Supporting documentation such as Event Management Service (EMS) logs, trace files, and a
processor dump, if applicable
If your local operation procedures require contacting the GCSC, supply your system number and
the numbers and versions of all related products as well.
7533
Out of sequence tape record (Expected sequence number: e,
Actual sequence number: a).
Cause. BACKUP or RESTORE encountered a BACKUP tape record that was not in correct order.
Three possible reasons are:
BACKUP was stopped in the middle of a backup operation, resulting in an incomplete BACKUP
tape. The "Bad Tape Format" was detected when unwanted or meaningless information was
encountered at the interruption point on the tape.
The BACKUP tape was corrupted in some way.
Either BACKUP produced an invalid tape, or BACKUP or RESTORE is not checking correctly
due to a software error.
Effect. BACKUP or RESTORE terminates.
Recovery. If the invalid format is a result of one of the first two causes, the files cannot be restored.
If you suspect the problem is a result of the third cause, contact your service provider and provide
all relevant information:
The information in this message
Description of the problem and accompanying symptoms
Supporting documentation such as Event Management Service (EMS) logs, trace files, and a
processor dump, if applicable
If your local operation procedures require contacting the GCSC, supply your system number and
the numbers and versions of all related products as well.
7534
Not from the same BACKUP tape set.
Cause. An attempt was made to back up a tape that is not part of the same BACKUP tape set as
the other reel(s).
Effect. BACKUP or RESTORE unloads the tape and prompts for the correct reel.
Recovery. Mount the correct BACKUP tape, and press Return at the prompt.
7535
Bad tape format (Too many data blocks found for file on
tape).
218 BACKCOPY, BACKUP, and RESTORE Messages