Hitachi WJ200 Series Quick Reference Manual page 75

Option Terminal
Function Name
Code Symbol
DWN Remote Control Down
28
Function (motorized
speed pot.)
UDC Remote Control Data
29
Clearing
OPE Operator Control
31
SF1 Multi-speed Select,
32
Bit operation Bit 1
SF2 Multi-speed Select,
33
Bit operation Bit 2
SF3 Multi-speed Select,
34
Bit operation Bit 3
SF4 Multi-speed Select,
35
Bit operation Bit 4
SF5 Multi-speed Select,
36
Bit operation Bit 5
SF6 Multi-speed Select,
37
Bit operation Bit 6
SF7 Multi-speed Select,
38
Bit operation Bit 7
OLR Overload Restriction
39
Source Changeover
TL Torque Limit Selection
40
TRQ1 Torque limit switch 1
41
TRQ2 Torque limit switch 2
42
Option Terminal
Function Name
Code Symbol
BOK Brake confirmation
44
LAC LAD cancellation
46
PCLR Pulse counter clear
47
ADD ADD frequency enable
50
F-TM Force Terminal Mode
51
Input Function Summary Table
ON Decelerates (decreases output frequency) motor
from current frequency
OFF Output to motor operates normally
ON Clears the UP/DWN frequency memory by forcing it
to equal the set frequency parameter F001. Setting
C101 must be set=00 to enable this function to work
OFF UP/DWN frequency memory is not changed
ON Forces the source of the output frequency setting
A001 and the source of the Run command A002 to
be from the digital operator
OFF
Source of output frequency set by A001 and source
of Run command set by A002 is used
ON Bit encoded speed select, Bit 1, logical 1
OFF Bit encoded speed select, Bit 1, logical 0
ON Bit encoded speed select, Bit 2, logical 1
OFF Bit encoded speed select, Bit 2, logical 0
ON Bit encoded speed select, Bit 3, logical 1
OFF Bit encoded speed select, Bit 3, logical 0
ON Bit encoded speed select, Bit 4, logical 1
OFF Bit encoded speed select, Bit 4, logical 0
ON Bit encoded speed select, Bit 5, logical 1
OFF Bit encoded speed select, Bit 5, logical 0
ON Bit encoded speed select, Bit 6, logical 1
OFF Bit encoded speed select, Bit 6, logical 0
ON Bit encoded speed select, Bit 7, logical 1
OFF Bit encoded speed select, Bit 7, logical 0
ON Perform overload restriction
OFF Normal operation
ON
Setting of b040 is enabled
OFF Max. torque is limited with 200%
ON Torque limit related parameters of Powering/regen,
and FW/RV modes are selected by the combinations
OFF
of these inputs.
ON
OFF
Input Function Summary Table
ON
Brake wait time (b124) is valid
OFF
Brake wait time (b124) is not valid
ON Set ramp times are ignored. Inverter output
immediately follows the freq. command.
OFF Accel. and/or decel. is according to the
set ramp time
ON Clear the position deviation data
OFF Maintain the position deviation data
ON
Adds the A145 (add frequency) value
to the output frequency
OFF
Does not add the A145 value to the
output frequency
ON Force inverter to use input terminals for output
frequency and Run command sources
OFF
Source of output frequency set by A001 and source
of Run command set by A002 is used
73
Description
Description