Hitachi WJ200 Series Quick Reference Manual page 55

Func.
Name
Code
DC braking time at start
a058
Carrier frequency during DC
a059
braking
Frequency upper limit
A061
Frequency upper limit,
A261
2nd motor
Frequency lower limit
A062
Frequency lower limit,
A262
2nd motor
Jump freq. (center) 1 to 3
A063
A065
A067
Jump freq. width (hysteresis) 1
A064
to 3
A066
A068
Acceleration hold frequency
A069
Acceleration hold time
A070
PID enable
A071
"A" Function
Description
Sets the duration for DC braking,
range is from
seconds
Carrier frequency of DC braking
performance, range is from 2.0 to
15.0kHz
Sets a limit on output frequency
less than the maximum
frequency (A004).
Range is from frequency lower
limit (A062) to maximum
frequency (A004).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
less than the maximum
frequency (A204).
Range is from frequency lower
limit (A262) to maximum
frequency (A204).
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
greater than zero.
Range is start frequency (B082)
to frequency upper limit (A061)
0.0 setting is disabled
>0.0 setting is enabled
Sets a limit on output frequency
greater than zero.
Range is start frequency (B082)
to frequency upper limit (A261)
0.0 setting is disabled
>0.0 setting is enabled
Up to 3 output frequencies can
be defined for the output to jump
past to avoid motor resonances
(center frequency)
Range is 0.0 to 400.0 Hz
Defines the distance from the
center frequency at which the
jump around occurs
Range is 0.0 to 10.0 Hz
Sets the frequency to hold
acceleration, range is 0.0 to
400.0Hz
Sets the duration of acceleration
hold, range is 0.0 to 60.0
seconds
Enables PID function,
three option codes:
00...PID Disable
01...PID Enable
02...PID Enable with reverse
output
53
Run
Mode
Edit
0.0 to 60.0
Defaults
Lnitial data Units
0.0 sec.
5.0 sec.
0.00 Hz
0.00 Hz
0.00 Hz
0.00 Hz
0.0 Hz
0.0
0.0
0.5 Hz
0.5
0.5
0.00 Hz
0.0 sec.
00 −