Test Run - Grizzly G0750G Owner's Manual

4. Make sure the wires have enough slack
between the strain relief and terminal connec-
tions so they are not pulled tight or stretched,
then tighten the strain relief to secure the
cord.
Note: The strain relief must be tightened
against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.
5.
test the strain relief to ensure it is properly
tightened by pulling the cord from outside the
box with light-to-moderate force. When the
strain relief is properly tightened, the cord will
not move inside the cabinet.
6.
install a nEMA 6-15 plug on the other end of
the power cord per the plug manufacturer's
instructions.
7.
re-install the main electrical box cover.
To avoid unexpected start-up, keep the
RESET button pressed in until instructed
otherwise in the Test Run.
8. plug the cord into the matching power supply
receptacle and power source as specified in
circuit Requirements for 220v on page 14.
Model G0750G (Mfg. Since 11/12)

Test Run

once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following: 1)
the motor powers up and runs correctly, 2) the
emergency stop/rEsEt button safety feature
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on page 68.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
before starting the lathe, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety features on this machine. failure to
follow this warning could result in serious
personal injury or even death!
To test run your machine:
1.
read and follow the safety instructions at the
beginning of the manual, take all required
safety precautions, and make sure all pre-
vious preparation steps discussed in this
manual have been followed and completed.
2.
Clear away all tools and objects used during
assembly, lubrication, and preparation.
3. Make sure that the chuck and jaws, if installed,
are secure (refer to chuck Installation on
page 30).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test.
-25-