Checking Error Codes - GReddy Turbo Kit Installation Manual

e-manage Information
• The e-manage included in this kit is preprogrammed for the this turbo kit.
• Do not attempt to adjust any of the setting in the e-manage.
• Any adjustments made can cause damage to the e-manage, engine and the
factory ECU.
As of 11/25/03 this kit is not a street legal kit. Please ignore the label on the
e-manage.
ACTIVE L.E.D.
(2) When the ignition is turned on, it will illuminate and flash GREEN.
(3) When it reaches to the A.A.V. setting RPM range, it will illuminate and flash ORANGE.
(4) When an error is detected it will flash RED.
INTERACTION L.E.D.
1. This will illuminate when there is a connection with PC.

Checking Error Codes

When the unit is powered up and if there are any errors, the ACTIVE L.E.D will turn
"RED" from "GREEN", and begin to flash.
If this happens shut the engine off and turn the ignition switch to "ON"
position to go to Self Troubleshooting Mode. While in the Self
Troubleshooting Mode, the L.E.D. will show the error code. Turn off the
ignition. Check the error code in the chart below and fix the problem.
The error code will show until the error is corrected.
Important!
Important!