GReddy Turbo Kit Installation Manual page 14

Vacuum hose for Wastegate Installation
Remove the factory engine cover. Locate the
rubber plug on the intake manifold and remove it.
Connect the 5∅ hose to the intake manifold and
by using the three way fitting and connect the 6∅
hose to each of the wastegate fitting.
Suction Pipe Installation
1. Install the Airinx air filter to the Suction pipe S-2 and S-4.
(Part Used #14, 15, 16, 17, 18, 19, 33, 36, 37, 40, 42, 43, 44, 52, 53, 67)
Install the S-1 and the S-2 (with AIRINX) to the right (passenger side) turbo inlet using
2.
provided hose and hose clamps and secure the Airinx to the chassis as shown. Bend
the Power steering line over towards the pulley so that the S-2 clears the line.
Install the S-3 and the S-4 (with AIRINX) to the left (driver side) turbo inlet using
3.
provided hose and hose clamps and secure the Airinx to the chassis as shown. Bend
the A/C line toward the engine so that the S-4 pipe clears the line.
Bend A/C
Line
(Part Used #30, 31, 59)
Bend Away
Airinx
Bracket
Airinx
Bracket