GReddy Turbo Kit Installation Manual page 16

Brake Check Valve Installation
Install the provided check valve as shown.
Injectors Installation
1. Remove the upper intake manifold collector, fuel rail assembly with injectors and
regulator.
2. Grind the top of the fuel rail as shown to clear the intake manifold.
Make sure not to grind too much. Grind the part on the bracket that is raised down flat.
Clean the rail thoroughly after grinding.
3. Install the 440cc injectors and reinstall the fuel rail using the provided spacer.
4. Cut the factory injector connectors and solder in the provided connector harness.
(Part Used #39, 46)
How to solder
①Strip the end of wires
③ Solder the wires
(Make sure to solder
Completely)
(Part Used #65)
② Twist the end together
④ Tape up the soldered area