Grandstream Networks GXV3615 User Manual page 14

Connect to the Camera using Static IP
If no DHCP server in the network, or the camera does not get IP from DHCP server, user can connect the
camera to a computer via cross-over cable, using static IP to configure the camera.
The default IP, if no DHCP server; or DHCP offer time out (3 minutes), is 192.168.1.168
1. Connect the computer via cross-over Ethernet cable directly to the IP camera GXV3615
2. Configure the computer using Static IP: 192.168.1.XXX (1<XXX<255, but NOT 168) and configure
the "Subnet mask" to "255.255.255.0". Leave the "Default Gateway" to "Blank" like below:
3. Power on the GXV3615.
4. Start the IE or Firefox browser when the network connection is up.
5. Enter 192.168.1.168 in the address bar of the browser.
6. The browser will ask for plug-in or ActiveX if not installed, otherwise it will get to Home page and
start to show the video captured by the camera (by default the camera enabled anonymous access)
7. Click "Configuration", the browser will ask credentials to authorize configuration.
8. Enter the administrator user name and password to access the Web Configuration Interface, the default
user name and password are both set to admin.
9. In step 6, IE will indicate that "This website wants to install the following add-on: GSViewerX.cab
from Grandstream Networks Inc.", allow the installation.
10. Firefox user need to download and install the plug-in to see the video, the plug-in for Firefox is here:
http://www.grandstream.com/products/tools/surveillance/firefox_plugin.exe
NOTE:
 Please temporarily disable Antivirus or Internet Security Software when download and install the
Grandstream Firefox plug-in for video or "GSViewerX.cab" for Microsoft Internet Explorer.
Grandstream Networks, Inc. GXV3615 User Manual
Firmware Version 1.0.4.38
Page 14 of 37
Last Updated: 03/2013