ABLE OF ONTENTS GXV3615 User Manual WELCOME..............................4 ..........................5 AFETY OMPLIANCES ..............................6 ARRANTY CONNECT YOUR GXV3615 ........................7 ......................... 7 QUIPMENT ACKAGE ONTENTS GXV3615 ........................7 ONNECTING THE PRODUCT OVERVIEW ..........................8 GXV3615 F ......................8 RONT AND...
Page 3
ROVISIONING 19: F ....................37 IGURE ACTORY ESET FROM NTERFACE ABLE OF ABLES GXV3615 U ANUAL 1: GXV3615 T ......................11 ABLE ECHNICAL PECIFICATIONS Grandstream Networks, Inc. GXV3615 User Manual Page 3 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
ELCOME Thank you for purchasing Grandstream’s GXV3615 cube IP camera, an innovative powerful next generation network camera for remote monitoring and surveillance over the LAN or Internet. It features cutting edge H.264 real-time video compression with up to 30 frames per second in full D1 resolution, delivering rich image clarity at rapid transmission rates.
Serious injury or death may be caused if any of the warnings below are neglected. Injury or damage to the equipment may occur if any of the following caution messages are Cautions: neglected. Grandstream Networks, Inc. GXV3615 User Manual Page 5 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Grandstream reserves the right to remedy warranty policy without prior notification. Caution: Changes or modifications to this product not expressly approved by Grandstream, or operation of this product in any way other than as detailed by this User Manual, could void your manufacturer warranty.
PC. Wi-Fi mode has to be initially configured via wired mode before switched to run in wireless mode. Grandstream Networks, Inc. GXV3615 User Manual Page 7 of 37 Firmware Version 1.0.4.38...
IP address obtained, device in normal operation Blink Green Device is transmitting data NOTE: Green light status can be disabled via web configuration page Grandstream Networks, Inc. GXV3615 User Manual Page 8 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Page 9
10/100 RJ-45 network port for connecting to Ethernet DC 12V Jack 12V DC power jack, UL Certified. 10. RESET Pinhole Press and hold for 30 seconds to Factory Reset the unit Grandstream Networks, Inc. GXV3615 User Manual Page 9 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
GXV3615W is Wi-Fi model and can use Wi-Fi for network connection. However, user has to use wired connection to configure the Wi-Fi parameter first before switch to use Wi-Fi connection. Grandstream Networks, Inc. GXV3615 User Manual Page 10 of 37 Firmware Version 1.0.4.38...
GXV3615 (or GXV3615W) Base Unit; Desk Stand (also as wall-mounting kit); Universal Power Supply; Network Cable; Quick Installation Guide Regulatory Compliance FCC, CE, C-tick Grandstream Networks, Inc. GXV3615 User Manual Page 11 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Google Chrome and Apple Safari support is NOT yet supported and status pending. Please temporarily disable Antivirus or Internet Security Software when download and install the Grandstream Firefox plug-in for video or “GSViewerX.cab” for Microsoft Internet Explorer. Grandstream Networks, Inc.
Page 13
10. Firefox user need to download and install the plug-in to see the video, the plug-in for Firefox is here: http://www.grandstream.com/products/tools/surveillance/firefox_plugin.exe NOTE: Please temporarily disable Antivirus or Internet Security Software when download and install the Grandstream Firefox plug-in for video or “GSViewerX.cab” for Microsoft Internet Explorer. Grandstream Networks, Inc. GXV3615 User Manual Page 13 of 37 Firmware Version 1.0.4.38...
Page 14
10. Firefox user need to download and install the plug-in to see the video, the plug-in for Firefox is here: http://www.grandstream.com/products/tools/surveillance/firefox_plugin.exe NOTE: Please temporarily disable Antivirus or Internet Security Software when download and install the Grandstream Firefox plug-in for video or “GSViewerX.cab” for Microsoft Internet Explorer. Grandstream Networks, Inc. GXV3615 User Manual Page 14 of 37 Firmware Version 1.0.4.38...
17. Motion Detection Alarm Indicator: If motion detection alarm triggered, the indicator will flash in red. Click the indicator icon to turn off the alarm indication. Grandstream Networks, Inc. GXV3615 User Manual Page 15 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
When click the “Language” tab, supported languages will be displayed in Figure 2. Click to select the related webpage display language. Figure 2: Web Language Switch • Currently firmware only support: English (default), Simplified Chinese and Russian. Grandstream Networks, Inc. GXV3615 User Manual Page 16 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
(*) If select this option, a valid DNS server must be configured under Basic Settings Networking button has to be clicked to save all the changes made to the device. Grandstream Networks, Inc. GXV3615 User Manual Page 17 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Slide to adjust the built-in speaker volume. • Power Frequency: Select correct local power frequency to avoid video flicking effect under fluorescence light condition. US is 60Hz. China is 50Hz. Grandstream Networks, Inc. GXV3615 User Manual Page 18 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
If MJPEG selected, reduce fps to minimum to save bandwidth and get better image Grandstream IP Camera provides two video streams, user can use them with flexibility. For example, the high-resolution stream for local recording; another low or high resolution for remote monitoring or Smartphone applications, or vice versa depending application scenarios.
HTTP port changed to 8088, the RTSP port should be 10088, both 8088 and 10088 should be configured for port forwarding in order for remote camera video access. Grandstream Networks, Inc. GXV3615 User Manual Page 20 of 37 Firmware Version 1.0.4.38...
• Key: Key for security enhanced Wi-Fi network the camera try joining. • Security Mode: The security mode Wi-Fi access point or router used. Grandstream Networks, Inc. GXV3615 User Manual Page 21 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
• STUN Server: Stun server FQDN or IP. If device behind a non-symmetric router, STUN server can help to penetrate & resolve NAT issue. Grandstream Networks, Inc. GXV3615 User Manual Page 22 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
This page allows user to configure SIP related parameters. GXV3615 can be configured as SIP endpoint to call out when alarm trigged; or allow permitted number to call in to check the video if Grandstream video IP phone is used. Figure 8-1: SIP Setting Page •...
Phone List/Phone Number: Callee or call receiver number when alarm call trigged. • White List/Phone Number: Phone numbers allowed to call into the camera. Grandstream Networks, Inc. GXV3615 User Manual Page 24 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
When SIP account registered, the status will display “Online” in Green. When SIP account unregistered, the status will display “Offline” in Red. Grandstream Networks, Inc. GXV3615 User Manual Page 25 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
When checked, no security enhanced. Any person can view the camera if knowing the IP or FQDN of the camera, but can NOT change anything, just view ONLY. Grandstream Networks, Inc. GXV3615 User Manual Page 26 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Automatic Upgrade: Checked to enable automatic firmware upgrade and provisioning. NOTE: Only XML based provisioning is supported by GXV3615 and GS surveillance products. Grandstream Networks, Inc. GXV3615 User Manual Page 27 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Click “Test” after configuration, if setting is correct, a test email will send out and “Test successful!” yellow bar will display like below Figure 13: SMTP Testing Page Grandstream Networks, Inc. GXV3615 User Manual Page 28 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Click “Test” after configuration, if setting is correct, a test FTP operation will be performed and “Test successful!” yellow bar will display if the operation is successful. Grandstream Networks, Inc. GXV3615 User Manual Page 29 of 37 Firmware Version 1.0.4.38...
Grandstream provide HTTP API to help 3 party company by using HTTP server or VMS to develop further solutions for its customers. Grandstream IP Camera and DVS (include GXV3615) are ONVIF certified. Grandstream Networks, Inc. GXV3615 User Manual Page 30 of 37 Firmware Version 1.0.4.38...
When checked, a SIP alarm phone call will be made to pre- configured number. • Upload to Alarm Center: When checked, the alarm video will be transferred to Alarm Center, like Grandstream free GSurf_Pro VMS software. Grandstream Networks, Inc. GXV3615 User Manual Page 31 of 37 Firmware Version 1.0.4.38...
NOTE: Grandstream free GSurf_Pro VMS software can be downloaded here: http://www.grandstream.com/products/tools/surveillance/gsurf_pro.zip • Upload to Alarm HTTP Server: When checked, alarm will be transferred to the HTTP server via HTTP API. • Email and FTP upload JPEG: When checked, a snapshot of trigger moment will be generated and email to pre-configured email account, or FTP to related Server.
Syslog Server: Syslog server IP or Domain Name • Syslog Lever: Lever of syslog message sent to the syslog server: None, Debug, Info, Warning, Error. Grandstream Networks, Inc. GXV3615 User Manual Page 33 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...
Software Upgrade via TTFP, HTTP or HTTPS This page allows user to configure firmware upgrade: Figure 18: Firmware Upgrade and Provisioning NOTE: Grandstream recommends end-user use the Grandstream HTTP server. Its address can be found at http://www.grandstream.com/support/firmware Current HTTP firmware server: firmware.grandstream.com ...
Microsoft IIS web server. Configuration File Download Grandstream SIP Device can be configured via Web Interface as well as via Configuration File through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The “Config Server Path” can be same or different from the “Firmware Server Path”.
Restoring the Factory Default Setting will DELETE all configuration information of the camera. Please BACKUP or PRINT out all the settings before approach to following steps. Grandstream will not take any responsibility if you lose all the parameters of setting or cannot connect to your VoIP service provider.
Reset from Web Interface This page allows user to configure dynamic network related parameters: Figure 19: Factory Reset from Web Interface Grandstream Networks, Inc. GXV3615 User Manual Page 37 of 37 Firmware Version 1.0.4.38 Last Updated: 03/2013...