Problem - Solution Table - Primera FX1200 Operator's Manual

5.4 Problem - Solution Table

Problem
Vertical Target Error
- Error Message
Out of Paper
- Error Message
Cutter Cover Open
- Error Message
Web Break Detection (Location)
- Error Message
Carriage Home Error
- Error Message
Paper is not feeding through the
FX1200 but rollers are turning
Dancer arms are topping out hitting
the top of the base frame.
Paper is ripping on the edges
Solution
1. The cutter sensor cannot find the
eyemark/target. Manually adjust the web so that
the target is in the carrier window. (3.3D)
2. The print quality of the target may not be
sufficient. Check for light or inconsistent printing
on the target.
3. The media may be feeding crooked. Check for
any frayed edges. Adjust guides accordingly (3.7).
4. The target may have been printed too close or
too far away from the edge of the media. Measure
the distance from the edge of target to the front
plate of the cutter. Go to Advanced Tab –
Advanced Offsets – Horizontal Target Offset. Set
the value to the measurement you took.
1. This can mean that you are out of Laminate or
your Supply Roll is empty
2. Lamination may be enabled but no laminate is
installed. Disable lamination.
1. The cutter cover must be closed.
2. Make sure the stop button is not engaged.
This means that the web is broken at some point
on the system. It typically happens at the Weeder
Roller. Reconnect the matrix, laminate film or
splice the web. If it continues to break, tension at
that point will need to be decreased or the cuts
may not be closing completely. (3.3F)
The cutter carriage is physically blocked from
moving forward. Open the cover and look for a
label jam. Clear the jam to clear the error.
Close the left and right nip points and/or the cutter
pinch rollers.
Close the left and right nip points.
Adjust the guide collars outward. (3.7)
58