Set Up Cutter; Load Cut File - Primera FX1200 Operator's Manual

3.3 Set Up Cutter

Note: Before setting up the cutter or making any cuts make sure the splice point is past the
cutter mechanism. Also make sure any wrinkles in lamination are past the cutter.
Warning: You should always cut smooth lamination to avoid damaging the cutter blades.
A. Load Cut file.
1. To select the cut file go to the Setup Tab, click the Browse button.
2. A browse screen will appear. Use the left column to navigate folders and the right
column to pick the cut file. You can browse to a network folder, a folder on the touch
screen hard drive or a USB memory stick.
3. The location of the last cut file will be the default location that appears on the right side
of the browse window.
4. A preview of the cut will appear. Below the preview, the file name, the number of
columns and the target status will be displayed. Use the zoom controls at the top of the
cut preview to view details of any area of the cut.
Note: If you want to avoid transferring files via USB stick, it is recommended that you set up a
shared folder location on your network that is accessible by both the cut file creation software
(PTPrint) and the FX touch screen computer.
21