Cut Settings - Primera FX1200 Operator's Manual

4.4 Cut Settings

Before creating a cut file you can adjust the Plotting Defaults and the Tool Options. Both of
these will affect how the knife travels along the cut path. They can be found on the Cut menu in
PTPrint.
Plotting Defaults
All settings should be set to the
settings shown with the
following exceptions.
Object start point. You may
want to adjust this if the
weeder is tearing the labels.
The positions listed correspond
to the page not the cutter. Left
on the page = Front of the
FX1200.
Tool Options
All settings should be set to the settings shown above with the following exceptions:
Overcut. Increase this value if the cut is not completing. This will usually show itself as a tear at
the cut starting point.
Trailing blade. This affects the path the knife takes to go around corners. Increase the value to
reduce tearing at sharp corners.
52