Set Up The Weeder (Foam Weeder Roller) - Primera FX1200 Operator's Manual

Section 3.4 Set Up the Weeder
Tools Needed: Utility Knife
1. Press "Test Cut file" repeatedly until the weeder score mark has reached or wraps
around the lower take up mandrel. Depending upon how many Test Cut file
sequences you ran, your weeder score mark may not have reached the lower take
up mandrel or may have already wrapped around the mandrel several times.
2. Make sure a weeder core is installed. Depending on the size of the job, a used
weeder core can be left in place or you may use a new core.
3. Open the right side nip point. This will allow you to manually position the web.
4. Complete the Weeder Score using a utility knife. Since the weeder score does not
cut all the way across the web you will need to cut the last 1/8 inch (2 mm) of label
from the front and back edge of the web. Gently pull back the label from the liner,
slip the blade between the liner and the label and finish the cut.
Note: Position the weeder score mark so that it is on top of the lower take up
mandrel. This will give you the best position to compete the cut.
5. Manually turn the take up mandrel backwards until the score mark is positioned after
the peel roller but before the slitter station
Peel
Roller
Matrix
Slitter Station
30