Find The Eyemark / Target - Primera FX1200 Operator's Manual

D. Find the Eyemark / Target
With your knives in position, cut file loaded, pinch rollers positioned, lamination enabled
(optional), you are now ready to make your first cut. These first cuts will allow you to analyze
the quality and position of your cut.
1. Run the system forward until the first eyemark is
close to carrier one.
2. Release the pinch rollers by pressing down on each
of the release latches.
3. Hold the paper beneath the guide rollers on either
side of the cutter.
4. Move the paper backward or forward until the
eyemark is in the window of the first carrier.
5. Engage the pinch rollers.
6. Press "Run 1 Copy"
7. If the FX1200 starts cutting, the eyemark has been found. If you receive an error refer to
section 5.4 for additional troubleshooting on the specific error displayed.
Eyemark
Carrier One
25