Consumables And Accessories - Primera FX1200 Operator's Manual

Section 2.3 Consumables and Accessories
Lamination Film
A 500 foot length of high gloss lamination film is included with the FX1200. Primera
recommends use of lamination film. Using lamination film has the following benefits.
•
Eliminates cutter and toner dust that would normally accumulate from cutting un-
laminated material
•
Adds gloss finish to otherwise matte paper. This is really the only way to add gloss to a
label. Since the toner from a digital printer such as the CX1200 is matte, printing on
glossy material will only create gloss on non printed areas. Lamination adds gloss to the
entire label and allows you to use cheaper matte paper.
•
Added UV protection.
•
Water resistance on paper labels. Waterproof labels (complete submersion of the label
in water) will still require the use of a synthetic material since the paper and adhesive will
still break down when subjected to continuous water contact.
•
Add strength to the label. This is especially important if the matrix pulled up on the
weeder has very thin edges or interior spacing.
•
Higher scratch resistance
Lamination film is available in a large array of thicknesses, types of adhesives, amount of UV
protection, etc. The most common films are made of polyester and polypropylene. Polyester is
generally more expensive but has fewer tendencies to yellow over time. The type of film
normally used on FX1200 is called "self-wound." This means that there is no liner; instead, the
film wraps around itself. Self-wound film is generally less expensive than film with a liner.
Laminating film with a liner can also be used if you order the optional Lamination Liner Mandrel.
The maximum web width for the FX1200 is 8.50". Primera recommends a laminate width of
8.25" for easier setup. The extra .25" will allow you to center the laminate on the media and
reduce the likelihood of it walking off the edge of the label roll.
Optional Cleaning Brush
You may elect to have a cleaning brush installed at the factory or you may add one later.
A cleaning brush may be necessary if you regularly cut labels without lamination.
The clean brush assembly includes a brush that turns when the labels feed through the system.
To clear the dust you must attach the brush to a vacuum system. The simplest implementation
of this could use a standard Shop Vac with a 2 inch hose adapter.
15