Adjust Cut Position - Primera FX1200 Operator's Manual

F. Adjust Cut Position
Cut lines not meeting offset
across the web
- The web is walking during
the cut. Make sure guides 3
and 4 before and after the
cutter are touching the web.
- The cutter carriage belt is
slipping. Contact Tech
Support.
Cut lines not meeting –
offset with the web
- Decrease Cutter Speed
- Increase Pinch Roller
Pressure
- Set the Acceleration
profile to Normal. This is
especially true for longer
labels.
Cut is not matching the
printed label.
- Adjust Cutter Offsets.
Touch the arrow to move
the cut line in that direction.
You can also touch the
Offset value to type in
specific offset value.
Cut is correct on the right
side of the page but gets
gradually worse as it moves
left.
- This indicates that the
label was printed stretched
or shrunk. The FX1200 can
compensate for this error
by increasing or decreasing
the Image Stretch.
Note: The arrows
correspond to the actual
direction on the web that
you want the cut line to
move. In the example to
the left we would press
the left and top arrows.
The Cutter Offset values
increase or decrease
counter intuitively in
relation to the direction of
the arrows.
27