Electrical Parameter Measurement
When the Product is turned on, it is in the dc voltage
measurement function. Figure 12 shows electrical
measurement connections. To select an electrical
measurement function from SOURCE or
MEASURE/SOURCE mode, first push for MEASURE
mode:
1.
Push for current, for dc voltage, h once for ac
voltage or twice for frequency, or q for resistance.
When you measure frequency, the Product tells
you to select a frequency range. If the measured
frequency is expected to be below 20 Hz, push
to select the lower frequency range, and then push
.
2.
Connect the test leads for your measurement function
as shown in Figure 12.
Note
Documenting Process Calibrator
Measure Mode
29