Fluke RF303 Operator's Manual page 60

RF303
Operators Manual
Table 3-2. Available Duplex Mode Commands (cont.)
Command
RDMODE
EXITMODE
SETLOAD:{parm}
RDLOAD
RDPOWER
3-24
Description
Prompts the Analyzer to
transmit the currently
selected mode.
Prompts the Analyzer to
exit the currently
selected mode.
Note: You must exit the
current mode before
entering another.
Sets the measurement
test load resistance from
50-750 ohms in 50 ohm
increments. Not
available in RFLKG
mode.
Resistance value of the
selected test load
appears in the display.
Prompts an Analyzer
power measurement in
watts. Not available in
RFLKG and RARF
modes.
Parameters Return Value
Required
None NONE
OUTPUT
RFLKG
RARF
None *
Values of 50- *
750 in
increments of
50
None RRRR (ohms)
Where RRRR is the
load value in ohms.
Formatted to four
digits with leading
spaces as required.
None PPP.P (w)
(Response)