Advertisement
Attach the Bench Frame (1)tothe FrontLeg(2)
withtwoMIOx 65mmBolts(40),twoMIO
Washers ( 44),andtwoMIONylonLocknuts ( 43).
Do not tightenthe Locknuts.
Attach the Bench Frame (1)totheCrossbar ( 4)
withtwoMIOx 81mmBolts(41)andtwo MIO
NylonLocknuts ( 43).
Tightenthe
IVll0 Nylon Locknuts
(43) used in
steps 1 through
3.
Attach the Weight Tube (16) inside the Leg Lever
(3) with an M8 x 58mm Bolt (52), two M8
Washers (56), a lOmm Spacer (32), and an M8
Nylon Locknut (55).
Press the 25mm Round Angled Cap (28) onto the
Weight Tube (16).
Grease an MIO x 68mm Bolt (54). Attach the Leg
Lever (3) with the Bolt and an MIO Nylon Locknut
(43). Do not overtighten
the Locknut;
the Leg
Lever must be able to pivot easily.
Orient the Backrest Frames (12) with the indicat-
ed holes closer to the bottom. Attach the Backrest
Frames to the Backrest Bracket (10) with four M6
x 40mm Bolts (49), four M6 Washers (48), and
four M6 Nylon Locknuts (51). Do not tighten
the
Locknuts.
44
4O
40
J
4
43
41
567
16
52
_rease
6
Advertisement
