Weider 1120 User Manual page 9

8, 8
Attach the Shroud (17) to the Top Frame (4) with
two M6 x 16mm Screws (62) and two M6
Washers (82),
Attach the Shroud (17) to the brackets on the
Stabilizer (2) with two M6 x 16mm Screws (62)
and two M6 Washers (82), Make sure the brack-
ets are inside the Shroud,
Tighten the Nylon Locknuts (56, 58} used in
steps 2--7.
Grease the MIO x 77mm BoUt(79), Orient the Leg
Lever (8) as shown, Attach the Leg Lever to the
Front Leg (7) with the BoUtand an MIO Nylon
Locknut (56), Do not overtighten the Locknut;
the Leg Lever must be able to pivot easily,
10, Grease the MIO x 80mm BoUt(80), Attach the
Pivot Frame (5) to the Top Frame (4) with the BoUt
and an MIO Nylon Locknut (56), Do not over-
tighten the Locknut; the Pivot Frame must be
able to pivot easily,
Attach the two Arm Pins (40) to the Pivot Frame
(5) with two M4 x 20mm Serf-tapping Screws
(69), Insert the Arm Pins into the two holes in the
Upright (3),
10
62
62
56 7
Welded
Support
69
4O
56
3
Grease
9