Extreme Networks EPICenter Guide Manual page 51

Figure 19: The Basic tab of the New Alarm Definition window
2 Click the Scope tab, and do the following:
a Make sure the All devices and ports checkbox is not checked.
b Select "Port" in the Source Type field.
c Select the device ("Summit_24") from the Device list.
d Select the port ("10") from the ifIndex list.
e Click the Add button to add Summit_24 port 10 to the Selection list.
The information in the Scope tab should look as shown in Figure 20.
EPICenter Concepts and Solutions Guide
Using the EPICenter Alarm System
51