System Status; Current State - Extreme Networks ExtremeWare Enterprise Manager Installation And User Manual

U P S
SING THE OLICY YSTEM
S S
YSTEM TATUS
The System Status block indicates the status of the policy configuration process.
• Data Complete indicates whether the policy system has sufficient information about
a host (end station) or user policy object, to compute valid QoS rules. For example,
you might not have entered an IP address for a host. A green check
that the data is complete. If DLCS is enabled, the Data Complete status will indicate
that the data is complete, even if information has not yet been obtained.
A red X indicates that additional information is still needed before the policy
system can compute QoS rules.
Note: If you have Allow Automatic DLCS Updates checked for a user (or end
station), then data will always be considered Data Complete, because the
policy system will assume that it will get the required parameters from DLCS
on the switch.
• QoS Computed indicates whether the QoS rules have been successfully computed.
A green check
A red X indicates that the QoS rules have not been computed since policy
definition changes were made.
Click Compute QoS to compute a new set of QoS rules.
• Configuration Complete indicates whether the Qos rules have been successfully
configured onto the appropriate network devices. A green check
the current QoS rules have been configured onto the appropriate network devices.
A blue question mark
unknown. You must compute the QoS rules to see a configuration status.
Click Configure Devices to initiate the configuration process. If the QoS rules have
not been computed, clicking Configure Devices will first cause those rules to be
computed, and then do the device configuration.
C S
URRENT TATE
The Current State block shows you the state of the policy system. The purple arrow
indicates the current state.
• Ready to Compute QoS Rules indicates that policy definition changes have been
made that require computation of new or modified QoS rules.
To start rule computation, click Compute QoS in the System Status block.
8-56
indicates that the rules have been computed successfully.
indicates that the configuration status of the devices is
indicates that
E W E M
XTREME ARE NTERPRISE ANAGER
indicates
I U G
NSTALLATION AND SER UIDE