Installing The Switch In A Four-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches
After the switch is secured to the rack, install and connect power supplies as described on
AC power supplies or on

Installing the Switch in a Four-Post Rack

To install the switch in a four-post rack:
1 At the back of the rack, attach a rear mounting bracket to each rear post, as shown in
Figure 104: Attaching Rear Mounting Brackets—Four-Post Installation
2 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
3 Set the switch on a secure work surface.
4 At the front of the switch, attach a rack-mounting bracket to each side as shown in
Position the bracket with the flange at the front edge of the switch.
132
page 136 for DC power supplies.
SH_145
Figure
Summit Family Switches Hardware Installation Guide
page 135 for
Figure 104.
105.