Connecting a SummitStack 128G/20G Stacking Cable
SummitStack 128G/20G cables are used to connect the 128-Gbps stacking ports on Summit X650 series
switches to 20-Gbps stacking ports on Summit X650 series or other Summit series switches. The
128-Gbps ports are on VIM1-SummitStack256 modules in Summit X650 series switches. The 20-Gbps
ports are on one of the following:
VIM1-10G8X module installed in a Summit X650 series switch
●
VIM1-SummitStack module in a Summit X650 series switch
●
VIM2-SummitStack module in a Summit X480 series switch
●
Rear panel of Summit X250e, X450, X450a, or X450e series switches.
●
To connect a SummitStack 128G/20G cable:
1 Connect the 128-Gbps connector to the VIM1-SummitStack256 module as follows:
a Holding the cable connector with the release tab on top, align the connector with the stacking
port on the VIM1 module in the Summit X650 series switch
Figure 81: Connecting the 128G Connector
b Firmly press the cable connector into the stacking port until the spring latch on top of the
connector clicks into place.
2 Connect the 20G connector as follows:
a Align the cable connector with the stacking port connector on the back of the switch
b Firmly press the cable connector into place on the mating stacking port connector.
c Align and tighten the retaining screws on the cable connector.
Summit Family Switches Hardware Installation Guide
SH_149
(Figure
81).
(Figure
82).
111