Removing A Summit X480 Ac Power Supply; Removing A Summit X480 Dc Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Removing a Summit X480 AC Power Supply

CAUTION
The PSU may be hot to the touch; wear thermal protective gloves when handling the PSU during removal.
To remove a Summit X480 AC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
grounding point.
2 Disconnect the AC power cord from the wall outlet and from the power input connector on the PSU.
3 Push the latching tab to the right as you pull outward on the handle to disengage the PSU internal
connectors (see
Figure 117: Removing an AC PSU
4 Carefully slide the PSU the rest of the way out of the switch.
5 If a replacement PSU will not be installed, install a cover over the unoccupied power supply bay.
NOTE
Unoccupied power supply bays must always be covered to maintain proper system ventilation and EMI levels.

Removing a Summit X480 DC Power Supply

WARNING!
Be sure to disconnect all power cables before you disconnect the chassis ground wire.
CAUTION
The DC PSU may be hot to the touch; use thermal protective gloves when handling the PSU during removal.
144
Figure 117).
SH_139
Summit Family Switches Hardware Installation Guide