Extreme Networks IP Service Manager User Manual page 53

Figure 5-6: Create IP Range Subscriber Wizard
2 Enter the subscriber name
The subscriber name is the key information for the subscriber. Once you have
entered the key information you can close the wizard by selecting Finish, but you
still may need to configure other parameters before you have a valid configuration.
For example, you may want to create a subscriber, and then go on to specify a
service bundle in the Service Library view, returning later to associate the service
bundle with the subscriber.
3 Enter the VLAN tag
Enter the VLAN tag to use if the IP range subscriber and IP aggregation point are on
different devices.
4 Select the IP aggregation point
The IP aggregation point represents the super-VLAN that this IP range subscriber
sub-VLAN is associated with. Every IP range subscriber must eventually be
associated with an IP aggregation point. The IP aggregation point can be on the
same device as the IP range subscriber or it will be automatically setup if it is one
IP Service Manager User Guide
Service Activation Tasks
5-11