Extreme Networks IP Service Manager User Manual page 36

Service Library
Figure 4-2: Create Service Bundle Upper Detail
3 Select the service category
Choose the service category based on the physical bandwidth of the port you will be
applying this service to. Your choices are 10, 100, and 1000 Mbps.
4 Set the default ingress and egress behavior
Set the behavior to one of the selections in the drop-down list. If you choose
"blocked" or "no rate limiting" the other choices are greyed out. If you choose "use
rate limiting" then also select the minimum and maximum bandwidth and priority.
For ingress rate limiting, the subscriber that you apply this service to must have a
loopback port defined.
5 Add policy based services
Select the policy based services that you wish to add from the Available Selections
panel by clicking on them, then select the Add button to move your selection to the
Current Selections panel. These policy based services will now be part of the service
bundle you are creating.
6 Select Finish
Select Finish to close the wizard.
4-6 IP Service Manager User Guide