Extreme Networks IP Service Manager User Manual page 55

Detailed Steps. The following steps are a more detailed explanation of the previous
section.
To create an IP aggregation point:
1 Launch the Create IP Aggregation Point wizard
To launch the Create IP Range Subscriber wizard, select Edit>Add>IP Aggregation
Point from the menu, or right-click in the IP Aggregation Point panel and select
Add>IP Aggregation Point from the pop-up menu. The Create IP Aggregation
Point wizard will appear
Figure 5-7: Create IP Aggregation Point Wizard
2 Enter the IP network address and netmask
This is the key information for the IP aggregation point. If device access has been
defined in Network Infrastructure Manager, then the IP aggregation point IP address
must come from the allowable pool of addresses.
3 Select the device
IP Service Manager User Guide
Service Activation Tasks
5-13