Extreme Networks IP Service Manager User Manual page 38

Service Library
Figure 4-3: Create Policy Based Service Wizard
2 Enter the service name
The name is the key information for the policy based service, but you must also add
at least one traffic policy before you can create a policy based service.
3 Select the service category
Choose the service category based on the physical bandwidth of the port you will be
applying this service to. Your choices are 10, 100, and 1000 Mbps. The service
category of a policy based service must match the service category of any service
bundles that it will be applied to.
4 Select the default ingress behavior
Set the behavior to one of the selections in the drop-down list. If you choose
"blocked" or "no rate limiting" the other choices are greyed out. If you choose "use
rate limiting" then also select the minimum and maximum bandwidth and priority.
For ingress rate limiting, the subscriber that you apply this service to must have a
loopback port defined.
5 Add at least one traffic policy
4-8 IP Service Manager User Guide