Viewing The System Status; Setting The Time Zone; Reset Factory Defaults - Toshiba 22AV60U Owner's Manual

Viewingthe digitaJsignal meter
You can view the digital signal meter in the ANT/CABLE
digital TV input source only.
To view the digital signal meter:
1 Press M_uand open the
Setup
menu.
2 Highlight Installati0n and press@.
3 A new set of Installation menu icons will appear. Open
the Terrestrial menu, highlight
Si0nal Meter,
and press
@.
4 Press AY4)" to select the antenna input and digital
channel whose signal you want to check.
Note:
• The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual
TV channel numbe_ Contact your local broadcasters
to obtain the RF channel numbers for your local digital
stations.
• The signal strength does not change between virtual
channels on the same physical channel.
To close the screen and return to the Terrestrial
menu:
Highlight Doneand press @.
To return to normal viewing:
EXiT
Press o.
Setting the time zone
The Time Zone setup will allow you to specify the correct
time zone for your region. This feature will allow the TV
status information to show the correct time zone information
(_' page 45).
To set the time zone:
1
From the
Setup
menu, highlight Installation and press @.
A new set of Installation menu icons will appear.
2
Highlight Time Zone
Setup,
and press @.
3 Press A or T to select the region, highlight Done, and
then press @.
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To set the Daylight Saving Time status:
1
Press _1 or _ to select Yesor R0, highlight Done,and then
press @.
Viewingthe systemstatus
To view the system status:
1
Press M_uand open the Setup menu.
2 Highlight Installati0n and press@.
3 A new set of Installation menu icons will appear. Open
the SystemStatusmenu, highlight System
Information,
and press @.
4 Press 4_ to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press @.
To return to normal viewing:
EXIT
Press O.
ResetFactoryDefaults
To reset all settings and channels to their factory
default values:
1
Press M_uand open the Setupmenu.
2 Highlight Installation and press @. A new set of
Installation menu icons will appear.
3
Open the System Status menu, highlight System
Information, and press @.
4 Press 4_" to scroll through the menu bar to select
FactoryDefaults.
5 Enter your PIN code (or 0000 if no PIN code has been set).
6 Highlight Yes and press @. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
To cancel the reset:
Highlight NOand press @.
27