Displaying Tv Status Information; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature - Toshiba 22AV60U Owner's Manual

OtherRERZA-LJRR ® functions
When the EnableREGZA-LINR and each item in the
REGZA-LINRSetup menu are set to On, the following
functions will be enabled.
TV Auto If a connected HDMI device starts playing
Input video or audio, the TV will automatically
Switch switch to the appropriate HDMI input.
TV Auto If a REGZA-LINK device is turned on, the
Power TV turns on automatically.
Device If the TV is turned offthe TV will send a
Auto message to turn off all of the REGZA-LINK
Standby devices connected to the TV.
Speaker
Preference
From this item, you can set your audio output
preference to the TV speakers or the audio
receiver speakers. When this item is set to
Audio Receiver, the TV remote can be used to
adjust or nmte the volume of the m_dio. This
item will be grayed out unless a REGZA-
LINK compatible audio receiver is connected.
Note: When you turn on the Audio Receiver, change its input
soume, or adjust the sound volume, the sound will be output
from the audio receiver's speakers even if TV Speakers has
been selected. Turn the TV off and on again to output the
sound from the TV speakers.
To set the REGZA-LINK "R_ Setup:
1 From the Setup menu, highlight REGZA-LINKSetup and
press @.
2 Press & or Y to highlight Enable REGZA-LINK
3 Press 4 or _ to select On.
4
5
Note: If you select Enable REGZA-L/NK Off, the other items
will be grayed out.
Press & or Y to highlight the NEGZA-LINK
Setup
item
you want to use, and press 4 or _ to select On or desired
mode.
• TV Auto Input Switch: On/Off
• TV Auto Power: On/Off
• Device Auto Standby: On/Off
• Speaker Preference: TV Speakers/Audio Receiver
To save the new settings, highlight Done and press @.
To revert to the factory defaults, highlight Reset and
press @.
DisplayingTVstatus information
To display TV status information using RECALL:
Press .E_LLon the remote control.
The following information will display (if applicable):
• Current input (ANT/CABLE,VIDEO 1, etc.)
• If ANT/CABLE is the current input, either "CABLE" (for
cable TV) or "ANT" (for over-the-air broadcasts).
• Channel number (if in ANT/CABLE mode)
• Channel label (if set)
• Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signal only)
• Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
• Game Timer (if set)
To close the RECALL screen:
Press .E_LLagain.
To display TV status information using INFO:
Press _%o on the remote control.
The following additional information will display for off air
digital channels (if applicable):
• Title
• Duration
• Detailed description
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing A or V while the RECALL or
INFO display is on-screen.
Understanding the auto poweroff
feature
The TV will automatically turn itself off after approximately 15
minutes if it is tuned to a vacant channel or a station that completes
its broadcast for the day.This feature functions in ANT/CABLE
mode only.
Understanding t he last mode
memoryfeature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the
TV when the power is resupplied.
Note: If it's possible, and you wll/ be away from the TVfor an
extended period of time you should unplug the power cord.
45