Channel Program; Programming Channels Automatically - Toshiba 22AV60U Owner's Manual

Programmingchannels into the
TV's channel memory
When you press _.] or _ on the remote control or TV
control panel, your TV will stop only on the channels you
progrannned into the TV's channel memory.
Follow the steps below to program channels into the TV's
channel memory.
Programming channelsautomatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
progrannned automatically, you can manually add or erase
individual channels in the channel memory.
Note:
, You must configure the ANT/CABLE input source before
programming channels (_. page 23).
• The automatic channel programming process will erases
channels that were previously programmed into the TV's
memory
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than
when the antenna input is configured for Antenna. This is
normal; however, once channel programming is finished,
you should not have to repeat the programming process
again unless your Cable TV service lineup changes
significantly,
To program channels automatically:
1
Configure the antenna input source, if you have not
already done so (_' page 23).
2 Press M_uand open the
Setup
menu.
3 Highlight
Installatien
and press@.
24
4
(A new set of Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Channel Program
to bring up the
Start,
and press @
again to begin channel programming.
Channel Program
5
The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message "Scanning channels, please wait" appears (as
shown above).
To cancel channel progrannning, press E_T on the remote
control (or highlight (;angel in the on-screen display and
press @).
When channel progrannning is finished, press _ or _ to
view the programmed channels.
Manually a|Jding and deletingchannelsin
the channelmemory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1
From the
Setup
menu, highlight Installation and press @.
A new set of Installatien menu icons will appear.
2 Open the Terrestrial menu, hightight(;llannel Add/
Delete, and then press @.
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number you
want to add, and then press @ to check the box.
(c'ol_til_ued)