Total Graphics Memory (Advanced Menu > Advanced Chipset Control); Sata Mode (Advanced Menu); Legacy Usb Support: (Advanced Menu); Boot-Time Diagnostic Screen (Advanced Menu) - EUROCOM Multimedia PC User Manual

Total Graphics Memory (Advanced Menu > Advanced Chipset Control)
Use this menu item to set the amount of system memory to be allocated for use by
®
Intel Dynamic Video Memory Technology for the graphics device. The default
memory size allocated is MaxDVMT (up to 384MB) and this may be adjusted to
128MB or 256MB (by pressing the spacebar to adjust) if required (see
Video Memory Technology" on page B -

SATA Mode (Advanced Menu)

You can configure SATA (Serial ATA) control to operate in either IDE (native/
compatible) or AHCI (Advanced Host Controller Interface) modes from this menu.
The SATA mode should be set to AHCI mode for this system (unless you are sure
your hard disk can only operate in IDE mode). If you are unsure of the mode your
hard disk supports contact your service center.

Legacy USB Support: (Advanced Menu)

Choose "Enabled" if you intend to use USB devices in systems which do not nor-
mally support USB functionality (e.g. DOS). The default setting is "Enabled" and
does not need to be changed if you intend to use your USB devices in Windows.

Boot-time Diagnostic Screen (Advanced Menu)

Use this menu item to enable/disable the Boot-time Diagnostic Screen (see
Power-On Self Test (POST)" on page 5 -
1).
2).
BIOS Utilities

SATA Mode
Selection
"Dynamic
If you have installed the
Windows 7 operating
system with AHCI mode
enabled (default
ting), DO NOT disable
AHCI mode (if you wish
to disable AHCI mode
you will need to reinstall
the Windows 7 OS).
"The
Advanced Menu 5 - 9
5
set-