Listening To Audio From A Connected Component - Sony MHC-GN770 Operating Instructions Manual

[] GAME INPUT VIDEO jack
Use a video cable (not supplied) to connect the
video output of the optional video game player
to this jack. You can then output video through
this system.
[] GAME INPUT AUDIO L/R jacks
Use audio cords (not supplied) to connect _e
audio output of the optional video game player
to these jacks. You can then output audio
through this system. To listen to the analog
sound of a connected video game, press GAME.
Notes
• To enjoy video game solmd, see "Enhancing video
game sound" on page 25, or see "Mixing video game
sound with other sotmd source" on page 26 for video
game sotmd effects
• The video game player image may appear on the TV
screen even if the system is tinned oft'.
• If you press GAME while the system is ofl\ the
system turns on, the fimction switches to GAME, and
the equalizer also switches to the previously selected
game preset effect
• If you press GAME while the system is on, the
fimction switches to GAME and the equalizer
antomatically switches 1o the previously selected
game preset effect
[] VIDEO/MD (AUDIO) IN L/R jacks
Use audio cords (not supplied) to connect an
optional analog component (VCR or MD deck)
to these jacks. You can then output audio
through this system.
[] CD DIGITAL OUT jack
(MHC-G N990/G N880/G N770/
GN660 only)
Use a digital optical cable (square, not supplied)
to connect the andio input of the optional MD
deck to this jack. You can then record digital
audio from this system.
Note
There is no digital audio ouiput from this jack during
playback of an MP3 andio track.
[] VIDEO OUT jack
Use a video cable (not supplied) to connect the
video input of TV to this jack.
1 Connect the audio cords.
See "Hooking up optional components" on
page 33.
2 Press VIDEO/MD to switch the function
to VIDEO or MD.
Start playing the connected component.
If you cannot select "MD" by pressing
VIDEOiMD repeatedly, hold down
VIDEO MD and then press I/(_) while the
power is on. The function will change from
"VIDEO" to "MD" and "MD" will appear
in the display. To change back to "VIDEO",
repeat the same procedure.
Note
If the solmd is disto*ted or too loud when "VIDEO" is
selected, repeat the operation described above lo
switch to "MD".
Tip
You can also press FUNCTION repeatedly on the
remote to select "VIDEO".
3408