Enginemaintenance; Engine Tipping; Lubrication; Adjusting The Height Of Cut - Snapper SPV2270HW Operator's Manual

22" self-propelled walk behind mower
Hide thumbs Also See for SPV2270HW:
Table of Contents

Advertisement

Available languages

Available languages

Maintenance
EngineMaintenance
Use the following maintenancesection to keepyour unit in
good operating condition. All the maintenance information
for the engine is in the engine manual. Beforeyou start the
engine, read this book.
WARNING:Beforeyou make an inspection,
adjustment(except carburetor),or repair, stop
the engine and disconnectthe wire from the
spark plug.
Engine Tipping
When you service the engine, inspect the blade, or clean the
underside of the mower housing; make sure to always tip the
engine with the spark plug up (Figure 15). Transporting or
tipping the engine with the spark plug down will cause:
• Hard starting.
• Engine smoking.
• Spark plug fouling.
• Oil or gas saturation of the air filter.
Figure 15: No forward engine tipping
Lubrication
1. For maximum performance, lubricate the wheels and all
pivot points with engine oil every 25 hours.
2. To lubricate the engine, refer to the engine manual.
Note: Do not lubricate the engine stop cable. Lubricants will
damage the cable and prevent the cable from moving freely.
Replace the cable if bent or damaged.
Adjusting the Height of Cut
_b
ARNING:The blade will rotate when the
engine runs. Beforeyou changethe height of
cut, stop the engine and disconnectthe wire
from the spark plug.
To change the height of cut, move the position of the
adjuster arm at eachwheel (A, Figure 16). Make sure each
adjuster arm is in the same position so that the mower will
cut level.
1. Disengage the adjuster arm.
2. Move the adjuster arm to another position.
Figure 16: Adjusting the height of cut
15

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Nspv2270hw78007097800755

Table of Contents