Enginemaintenance - Snapper 355Z Series Operator's Manual

EngineMaintenance
Refer to engine owner's manual for all engine maintenance
procedures and recommendations.
Adding Fuel
To add fuel:
1. Stop the engine and allow to cool for at least 3 minutes.
2. Removethe fuel cap (seeA, Figure 31).
3. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE."Do not overfill. Refer to your engine manual for
specific fuel recommendations.
4. Install and hand tighten the fuel cap.
Fuel Filter
The fuel filter is located in the fuel line between the fuel tank
and fuel pump. If the filter is dirty or clogged, replaceas
follows:
1. Disconnectthe negative battery cable.
2. Placea container below the filter to catch spilled fuel.
3. Using pliers, open and slide the hose clamps from the
fuel filter (C, Figure31).
4. Removethe hoses from the filter.
5. Install the new filter in the proper flow direction in the
fuel line.
6. Securewith the hose clamps.
7. Reconnectthe negative battery cable when finished.
A WARNING
Gasoline is highlyflammable and mustbe handled
with care. Never fill the tankwhen the engine is still
hot from recent operation. Do not allow open flame,
smokingor matchesin the area. Avoid over-filling and
wipe up anyspills.
Do not remove fuel filter when engine is hot, as spilled
gasoline may ignite. DONOT spreadhose clamps
further than necessary.Ensureclamps grip hoses
firmly over filter after installation.
Do not use gasoline containing METHANOL,
_ asohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damagecould
result.
...... i:J
Figure 31. Maintenance
A, Fuel TankCap
B. Transmission Oil Caps
C. Fuel Filter
30 www.snapper.com