Gap Removal; Replacing V-Belt - Grizzly G9036 Owner's Manual

13" x 40" gear-head lathe
Hide thumbs Also See for G9036:
Table of Contents

Advertisement

gap removal

A section of the bed called the "gap" is located
just under the spindle and can be removed for
turning large diameter parts or when using a large
diameter faceplate.
the gap is installed, then ground, at the factory
during lathe assembly for precise fit and align-
ment. Factors during the remaining assembly
apply additional forces to the gap; therefore,
replacing the gap to the original position will be
very difficult. if you choose to remove the gap,
the mating surfaces of the gap will probably
not sit flush with the bed if you ever re-install
it. for that reason, removing the gap is consid-
ered a permanent alteration to the machine.
tools needed
hex Wrench 8mm .............................................. 1
heavy dead Blow hammer ............................... 1
to remove the gap:
1.
disConneCt lAthe FroM poWer!
2.
remove the four cap screws that secure the
gap to the bed (figure 101).
figure 101. gap cap screws.
3.
use the dead blow hammer to tap the gap
upwards and out of the bed.
-56-
Qty
Cap screws

replacing v-belt

tools needed
phillips screwdriver #2 ...................................... 1
Wrench 17mm.................................................... 1
to replace the v-belts on the lathe:
1.
disConneCt lAthe FroM poWer!
2.
remove the backsplash and headstock end
cover.
3.
remove the tension off the old v-belts by
loosening the motor mount bolts (figure 102)
and sliding the motor up.
figure 102. location of motor mount bolts.
4.
remove the old belts and install the new
ones as a matched set.
5.
push down on the motor with one hand to
tension the belts, then tighten the motor
mount bolts with your other hand to lock the
motor in place.
6.
Check the belt deflection as shown in figure
103 and re-adjust if necessary. the proper
deflection is approximately
7.
replace the end cover and the backsplash.
Deflection
deflection
should be
Approx.
"
1
4
figure 103. Belt deflection.
Qty
Motor
Mount
Bolts
".
1
4
Pulley
Pulley
Model g9036 Mfg. 7/08+

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents