section 4: operation
damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
if you have never used this type of machine
or equipment before, We strongly rec-
ommend that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. regardless of the con-
tent in this section, grizzly industrial will
not be held liable for accidents caused by
lack of training.
complete the test run & break-in proce-
dure on page 16 before using this lathe for
any cutting or threading operations; other-
wise, gear box damage will occur.
Model g9036 Mfg. 7/08+
figure 14. headstock controls.
the jog button (figure 14) powers up the spindle
and leadscrew (if engaged) only while held. this
button only works if the stop button has been
reset and the brake pedal is not depressed.
the stop button (figure 14) cuts power to the
motor to stop the lathe. it does not instantly
stop the spindle as does the brake. After being
pressed, this button stays down until it is reset.
reset the button by twisting it clockwise until it
coolant on/off switch
the coolant on/oFF switch (figure 14) toggles
the coolant pump ON or OFF. never turn the cool-
ant pump on when coolant is not in the reservoir
or the pump may burn up. this is considered
abuse and will not be covered under war-
g9036 13" X 40" gear-head lathe