Removing The System Memory (Ram) - Clevo W110ER Service Manual

Disassembly

Removing the System Memory (RAM)

Figure 8
RAM Module
The computer has two memory sockets for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
Removal
DDRIII (DDR3) Up to 1333/1600MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules sup-
ported are 1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST rou-
a. The RAM modules will
tine once you turn on your computer.
be visible at point 1
on the mainboard.
Memory Upgrade Process
b. Pull the release lat-
ches.
1. Turn off the computer, turn it over and remove the battery
c. Remove the module.
2. The RAM modules will be visible at point
3. Gently pull the two release latches (
arrows
4. The RAM module
5. Pull the latches to release the second module if necessary.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module's
performance.

4. RAM Module
• 2 Screws
2 - 12 Removing the System Memory (RAM)
&
2
(Figure 8b).
will pop-up ( Figure 8c
4
6
a.
1
b.
2 3
(page 2 - 5) and the component bay cover
on the mainboard (Figure 8a).
1
) on the sides of the memory socket in the direction indicated by the
3
) , and you can then remove it
.
c.
(page 2 -
4
6).