Removing And Installing A Processor - Clevo W110ER Service Manual

Removing and Installing a Processor

Processor Removal Procedure
1. Turn off the computer, remove the battery
2. The CPU heat sink will be visible at point
3. Remove screws , , ,
7 6 5
size of the screwdriver is below 4mm. when removing or tighting screw
degree angle from the mainboard
4. Carefully lift up the heat sink
h
a.
A
(page 2 - 5) and the component bay cover
(Figure 5a) on the mainboard.
A
, , and , the reverse order indicated on the label. *Note: Make sure that the
4 3 2 1
(Figure 5b).wo tab
off the computer by pulling the two tabs
B
b.
(page 2 - 12).
, and its position should be at a 90
6
.
C
7
C
B
2
4
5
C
3
1
6
Removing and Installing a Processor 2 - 9
Disassembly
Figure 5
Processor Removal
a. Remove the cover and
Iocate the heat sink.
b. Remove the screws in
the order indicated.
6

B. Heat Sink
• 7 Screws