Epson Aculaser C1600 User Manual page 83

Symptom Cause
With N-up on Both the driver and the
multiple prints, application have been set for
the output is collation.
incorrect.
You hear unusual The printer is not level.
noises.
There is a foreign object stuck
inside the printer.
Media is wrinkled. The media is moist from
humidity or having water spilled
on it.
The media feed roller or fuser
unit is defective.
Unsupported media (wrong
size, thickness, type, etc.) is
being used.
You do not know -
the procedure for
returning the
settings on the
Panel tab of the
Remote Panel
Program to their
defaults.
You do not know -
the procedure for
returning the
settings on the
User Service tab of
the Remote Panel
Program to their
defaults.
Solution
For N-up on multiple prints, choose Collate only in the
driver's Basic Tab. Do not set collation in the application.
Put the printer on a flat, hard, level surface.
Turn off the printer and remove the object. If you cannot
remove it, contact Technical Support.
Remove the moist media and replace it with new, dry media.
Check them for damage. If necessary, contact Technical
Support with the error information.
Use Epson-approved media. See "Print Media" on page 25.
Exit the Remote Panel Program with the icon in the Windows
notification area (right end of taskbar), and then start up the
utility again.
Since the default settings appear when the utility is started
up again, click the Apply button. For details on exiting the
Remote Panel Program, refer to "Closing the Remote Panel
Program" on page 24.
Exit the Remote Panel Program with the icon in the Windows
notification area (right end of taskbar), and then start up the
utility again.
Since the default settings appear when the utility is started
up again, click the Upload button. For details on exiting the
Remote Panel Program, refer to "Closing the Remote Panel
Program" on page 24.
AcuLaser C1600 User's Guide
Troubleshooting 83