Dell OpenManage Network Manager Client Manual page 123

• Entity Type: Port
• Entity Type: Interface, Logical interface
CAUTION:
To successfully retrieve Custom attributes, you must first create them. See Edit Custom Attributes on
page 89.
You can also configure more limited variables that are slightly more efficient in performance, if not
as detailed as those described in the following section.
For example, you can retrieve the following attributes:
{RedCell.Config.EquipmentManager_Custom1}
{RedCell.Config.EquipmentManager_Custom2}
{RedCell.Config.EquipmentManager_LastBackup}
{RedCell.Config.EquipmentManager_LastConfigChange} and
{RedCell.Config.EquipmentManager_HealthStatus}
NOTE:
If the entity does not contain/return these values, then the message [No data for <attribute name>]
appears in the email instead.
Basic Variables
Attribute
Name
Message
Entity Name
Equipment Manager
Name
Device IP address
Entity Type
Instance ID
Protocol Type
Protocol Sub Type
Receive Time
Region
Severity
Source IP address
Description
The event / alarm name
Description from the event
The entity (interface, card...) name
The name of the equipment, parent or chassis. {EquipMgrName}
the IP of the device in alarm
Type of entity (Router, and so on)
An identifier for the event
Of originating alarm (SNMP, syslog, etc.)
Inform, Trap, [blank] (for internal events)
The mediation server partition name.
0 - cleared, through 6 - critical, from Alarm
Definition
The IP of the component sending the alarm
Email Action Variable
{Name}
{Message}
{EntityName}
{DeviceIP}
{EntityType}
{InstanceID}
{ProtocolType}
{ProtocolSubType}
{RecvTime}
{Region}
{Severity}
{SourceIP}
Event Processing Rules | Key Portlets
123