Table of Contents
Advertisement
Re te
C@ntr@J
Using Direct Entry
],
Turn
on
the
conlponent
you
_,ant
the
ren_o[_,
to
operate.
2.
Look up tile brand and code number(s)
l_)r the component
on the code list on page 26.
3.
Press and hold the cnmponenl
button that corresponds
to the component
you want the
remote to operate
(VCR1, DVD, etc.)
4.
Enler the code from the code list.
5.
Release the component
button.
6.
Press ON.OFF
lo see if the component
responds
lo the remole commands.
If it doesn't,
try
pressing the component
buuon and then ON*OFF again.
7.
If you get no response,
repeat these steps using the next code listed tk)r your brand until the
component
responds
to the remote commands.
Tip
The buttons
might
operate differently
for
other components,
especially when you're
using another
component's
menu
system
How to Use the Remote After You've
Programmed
It
Once
the remote
has been
programmed
successl\_lly,
you are ready
to use it to control
your
cnmpnnen[s.
To operale
the component:
1.
Press
the component
button
(TV, VCR1, VCR2, DVD, ALX, or SAT*CABLE)
lo set the remote
to operate
the component.
2.
Press
ON-OFF
to turn the component
ON or OFF.
3.
Use the remote
bul/ons
thai apply
to that component.
Note:/i'.YOZ_
keep pressin_,g bJ_ttons and
tloll)irlg happetl._,
the relJ_ole i._proha!)]),
in the
u rorlg mode,.
Yoz_ tnz_st press
the cotnponenl
bullon
that matches
lhe colnponetll.gou
want
to operate
(_.e., il'.goz_ want
to operate
the VCR, press" VCRI on hSe remote
contl_t
to
put
hSe remote
in VCR triodes.)
25
Advertisement
Table of Contents
Troubleshooting
